If you’re looking to make your ceiling look more like your bedroom, this article will help you get the job done.
If you don’t know how to do ceiling TV mounting, read on.1.
Install a ceiling height fixture2.
Install the ceiling height in a way that lets you see the ceiling3.
Install or buy a ceiling stand4.
Install some kind of wall support5.
Install your ceiling height stand6.
Install another ceiling height or ceiling height extension7.
Install and install a ceiling extension8.
Install an extension to the ceiling and adjust the height for your room.
The first thing to do is to install a tall ceiling height.
Most ceiling height stands come with a bracket for attaching to the wall above the ceiling, but you’ll want to purchase a DIY version if you can.
This allows you to use a flat screwdriver to attach the brackets to the base of the wall.
The reason we recommend you use a DIY stand is that it allows you the ability to adjust the heights of the brackets by adding or subtracting the height from the height of the ceiling.
The more you adjust the position of the bracket on the wall, the better it will hold the ceiling in place.
A flat screw driver should work well for most DIY ceiling height units.
For a DIY ceiling stand, you’ll need a drill bit that’s about an inch or so in diameter.
You can also use a ruler or tape measure.
For our purposes, we’ll use a pair of scissors.
You’ll also need to attach a pair or three of screw-on hooks to the bracket base, and a couple of screws to the stand itself.
Here’s how to install the bracket.1) Cut off the end of a 2×4 that has been installed on the ceiling above the floor.
You may have to trim off a bit of the material.
This is OK if you don.2) Measure the height at which you want to attach your ceiling.
For this DIY unit, it’s 1.5 feet.3) Mark the location of the height bracket.
It should be located at the bottom of the top part of the 2×2.4) Mark a number of inches on either side of the opening for the bracket to sit on.5) Measure out the opening at the top of the piece.
The opening should be about 1.75 inches from the edge of the base.6) Drill a small hole into the top and bottom of one of the screw holes, then drill a small screw hole into each other.7) Attach the bracket and the bracket mounting hardware to the end with the drill bits.
The hardware should sit on the end where the screw hole was drilled.8) Drill three holes in each end of the hardware.
Use a 1-inch bit for each hole.9) Screw the brackets onto the base using a flat or hex wrench.
The screws should sit just slightly above the base and are not too deep.10) Screw in the extension cord.11) Attached to the extension, hang the bracket from the ceiling using the wall mount extension.
If your ceiling is really high, you may want to hang the extension from the top edge of your ceiling instead.
If not, you can just hang the extensions from the base in place, or simply use the extension.12) You’re done!
You’ll want a few hours to let the bracket sit on your floor, so make sure you check the bracket before putting it on the floor again.
The ceiling will look a lot different once the brackets are installed, but it will still look pretty darn cool.